Panel voice commands out of sync after last update

[Ron]

After updating the Archer profile (from the email request), my left panel and some other voice commands now do not function. For example, if I say "navigation", it will work. But if I say "contacts", it echo's "contacts" but the tab is not changed. Similarly for "transactions". On the up front panel, launch the fighter get's confused (you can see it going to the wrong tabs). For the most part, most of my normal commands work but these don't (and then others don't like "request docking" because it can't open the contacts tab). I uninstalled and reinstalled the latest versions of all voice packs with no luck. And, this all seemed to occur after the Archer update (but I can't be sure of that). Also, I have not manually tabbed around the cockpit (I realize that can mess up the voicepack sychronization - where it thinks it is). This happens immediately after starting Elite. My voice attack startup log doesn't show anything unusual, Singularity v2.3.9, voice attack v 1.8.5, hcs plugin v 3.4.5, all voice packs load fine, no missing keybinds, etc.

Thanks for your help!

[Gangrel]

This sounds like a case of the panel tracking getting lost

[Ron]

Agreed. But, it's not lost because of manual panel navigation because I didn't manually do anything prior to being lost. And, in those instances in the past when it was lost, I could sync it up by simply going to the tab that the pack thought is was on and then going from there. That doesn't work either. I'm in VR mode if that matters. And, my mirrored display is on a 4k monitor that is scaled to 150% (if that matters). Any suggestions? I sure would like to get this all working normally like it used to!

Thanks!

[Ron]

So, any ideas on how to correct this? Or do you think it's a bug in the packs that will be resolved with a later update?

[TheThingIs]

we are not aware of any issues with the tracking

The general rule for tracking, when it's out of sync, is to move all tabs on all pages to their far left positions and then say "run diagnostics" to reset them.